mercman from oz
Well-known member
KULTULZ posted this picture of a 56 Ford that had been made into a Ranchero. I thought that I would start of a new Thread for these "utes".
Here is one with a lot of detail work done-
Made from a Parklane maybe? beautiful!!![]()
KULTULZ posted this picture of a 56 Ford that had been made into a Ranchero. I thought that I would start of a new Thread for these "utes".
Made from a Parklane maybe? beautiful!!
Don't think it started out as a Parklane, but rather a Crown Vic. The Parklane still had the taller windshield than the Crown, and it would take a lot of work to make the "Crown" fit a wagon roofline. JMHO![]()
KULTULZ - Are we seeing the same "Ute" above? In the top picture, it appears to have the plexiglass roof, yet not in the bottom picture? Also, spotlights on the top vehicle and not on the bottom vehicle - or am I incorrect? I would like to see some straight on side pictures of these Utes:
That reminds me. FORD made a RANCHERO from a later 80's FAIRMONT SW. I'll see if I can find those photos....the Truckstang appeared to be "bob-tailed" until 8 inches were added to the rear quarters. I don't have a working tailgate, as the Truckstang was a styling exercise; however, it was constructed in 1990/91, and is going to receive new paint in the near future - I may add a tailgate, just for fun.
That reminds me. FORD made a RANCHERO from a later 80's FAIRMONT SW. I'll see if I can find those photos.
To produce the Durango, National Coach Works used the body of the Ford Fairmont Futura two-door coupe. Aft of the B-pillar, the roof was removed along with the trunklid and rear seating area. Behind the rear seats, the company added a flat-floor fiberglass cargo bed along with a bulkhead and new rear window behind the two front seats. The rear fascia above the bumper was redesigned into a fold-down tailgate. As the tailgate included the license plate and taillamps, the Durango was produced with a disclaimer warning drivers from driving with the tailgate in the down position.[1][4]
I have been ciphering on these and believe the easiest (and cheapest) way to go about it would to be chop a CUSTOM WAGON, and if becoming a CROWN trim-out, actually replace the front roof section and windshield.
Hopefully......, someone would not start with an actual PARKLANE or CROWN as I imagine they are getting scarce and worth more restored.