Radiator Splash Shield Fitment
- Thread starter mountinpie
- Start date
Kevin in NJ
Well-known member
Hard to be 100% sure with these pictures, but I think your fenders are not set up properly. Looks like the that forword point is push towards the center and up.
How does your light bar fit with no fenders on the braces?
You can find hints on setting up the fenders in the link to my website below.
How does your light bar fit with no fenders on the braces?
You can find hints on setting up the fenders in the link to my website below.
mountinpie
Member
Sorry guys, can't understand why my pics are rotated.
I'll check the fit of the light bar tomorrow. It seems like the fender matches up well with most of the shield except for the forward point.
I'll check the fit of the light bar tomorrow. It seems like the fender matches up well with most of the shield except for the forward point.
mountinpie
Member
Yes, as far as I know everything is original. The holes on the fenders line up perfectly with the frame and everything else looks good, just seems like the holes in the shield won't line up correctly.
RawhideKid
BANNED
I am wondering, are the holes in the shield too far forward, or too far back to line up?
SeaSlugs
Well-known member
somethings wonky... can you get a pic of the inner part of the fender where the hood latches are? like have the pic show where its meeting with the splash apron and down the side where the hood latches go...something looks too wide/ not wide enough - not sure if its the fenders or the splash apron...
mountinpie
Member
Seems like the holes are too close together which spreads the front point. I'll do some fiddling tomorrow and get better pics to share.
RawhideKid
BANNED
Ya know what I would do, and this applies to every place with multiple screws to fit, loosen all the screws on the hood sills and fender and see how that lines up.
Larry Jenkins
BANNED
A long time ago, I realized that you should keep associated fasteners somewhat loose to allow final fitting to prevent situations like yours.
If you tighten fasteners that will be attached to other parts, you may experience hole alignment problems.
Take front fenders. Count the many places they attach to other parts. Rawhide Kid talks about this..
mountinpie
Member
Thanks Ken, I appreciate that. I did some additional checking this morning.
This is a '30 Tudor. All fender bolts are loose and the light bar fits good. I ran a straight edge along the fender and it looks good, not so with the shield. I also measured about 1-1/4" from the fender bolt hole to the edge of the fender. On the shield that dimension is less than 1". Understanding that the shield needs some work, I don't see how I can make up that 1/4".
This is a '30 Tudor. All fender bolts are loose and the light bar fits good. I ran a straight edge along the fender and it looks good, not so with the shield. I also measured about 1-1/4" from the fender bolt hole to the edge of the fender. On the shield that dimension is less than 1". Understanding that the shield needs some work, I don't see how I can make up that 1/4".
Attachments
mountinpie
Member
Tom Wesenberg
Well-known member
I can't tell in the 3rd picture, but original aprons are convex on the side panels, while repro ones are flat.
mountinpie
Member
Thanks Tom, they do have a slight curve to them, but I'm wondering if I should ty to pick up a better one, maybe in Gettysburg. If not, any recommendations for a good repro? Thanks again.
mountinpie
Member
Maybe I didn't explain correctly, but it's not the length of the sides, it's the hole placement.
