Pulling the head.

Franchise_24

Franchise_24

Well-known member
I need to take the head off on my Leatherback. I have everything taken apart, so is there a trick to getting the head lose to start to lift it off? I didn't want to get too rough with it, or hurt the engine block or anything. Thanks.
 
You are going to trash this head gasket anyway so time to get friendly with PB Blaster on the studs, your putty knives, and a big hammer. If you are careful you will not scratch the block surface. Don't go in deep enough to hit any valves and go around and around the edge of the head with the putty knives. If it is still stuck and stubborn, then you can go up in size to screwdrivers, wooden wedges, etc. .
 
Bill Stipe makes this handy dandy head puller that is available from most parts vendors as well. It works like a charm.
 

Attachments

  • Head Puller.jpg
    Head Puller.jpg
    51.2 KB · Views: 15
I can tell you this,if the head is stuck fast it will support the complete weight of the front of the car without budging,I just went through this! I had eye hooks in 2 sparkplug holes.
 
rocket1 said:
I can tell you this,if the head is stuck fast it will support the complete weight of the front of the car without budging,I just went through this! I had eye hooks in 2 sparkplug holes.
Click to expand...

"hang it" by the head and soak the studs. you can dam around the studs to hold more fluid. Use wooden shims and drive them into the gasket as well.
 
I have found that if you loosen the head bolts about two threads and hit the starter with the spark plugs installed the head will "pop" up and be a piece of cake to remove. This is actually a tip in Les Andrews book and it works like a champ. Good luck.
 
Took the head to the machine shop and it has a crack in it by the water inlet area. You don't really fix something like that do you? Just replace it?
 
I'm still using the stock head, but picked up a 5.5 head from Bert's in Denver when I stopped there. The 5.5 head should give a noticable improvement in horsepower, and it should run more efficiently, so you get better fuel economy and lower operating temp.
 
I'm with Tom. You will mostly notice better pulling power at lower RPM which makes the car more pleasant to drive. Yes, even more grunt - the Model A is notorious for having lots but this head will give you more and is just about a "must have" if you run an overdrive.
 
Sometimes it helps,sometimes it doesn't. It would be my first try before driving wedges and running the risk of breaking something.
 
You must log in or register to reply here.
Back
Top