Pressurized oiling system.

Hey Keith,
Well, I think that you are observant :) ! At least , you got me to take closer look at my posted picture. Although not my A block, but belongs to someone that I know, it can be improved in that gasket area. After making the block VERY clean in that area, JB Weld would restore the broken out gasket surface.
But, this area is not critical for sealing as bottom of valve chamber.
 
Mike V. Florida said:
As Bob C said, that's the hole the distributor shaft comes down to mate with the oil pump drive bearing and gear.
Click to expand...

The car could be using one of those distributors driven off the timing gear. I saw a setup like this on an A400 for sale at Pate Swap meet last year. It was a neat set up.
 
Jordan said:
The car could be using one of those distributors driven off the timing gear. I saw a setup like this on an A400 for sale at Pate Swap meet last year. It was a neat set up.
Click to expand...

Hey Jordan,
Did you get a picture of that setup that you can share ?
C. Yapp makes or made a front timing cover setup where a front driven distributor is mounted, wonder if it was that make ?
 
You must log in or register to reply here.
Back
Top