paw spring

NSDWS

NSDWS

Member
This is a small thing but does any one know how to R&R one of these things.
Photo's attached. My spring is broken and I don't see any way of removing the pin that holds it in.
 

Attachments

  • IMGP0402.jpg
    IMGP0402.jpg
    56.6 KB · Views: 171
  • IMGP0403.jpg
    IMGP0403.jpg
    61.4 KB · Views: 148
The locking pawl appears to be riveted. Rivets can be sourced though Hanson or other suppliers. http://www.hansonrivet.com/

If your not a stickler for authenticity, you could drill the rivet head & punch it out then replace it with a screw and locking nut after the spring function is repaired. You would need to get a good fit to insure the locking pawl functions as it should.
 
I tried to rivet mine and then it was to tight, I ground the rivet head back off and then used a shoulder bolt and nylon insert lock nut. I am happier with the way it releases now. I got the shoulder bolt from Mcmaster Carr. I don't plan on having it judged.

Regards,

Brian
 
I haven't replaced it yet but have seen the springs on several web sites. Not sure if Carpenters had them but will check since their only a few miles away. I will replace with a bolt and lock nut or if I can find the right size pin i'll use that and a small carter key.
 
I drilled the upset side of the pin, replaced the spring, put the pin back in place and used a small tack weld to secure it.
 
You must log in or register to reply here.
Back
Top