Painting Project Update

bobgreco

bobgreco

Senior Member
Well, it has been a while since I posted an update. Progress has been slowed by work and work related travel. (its the darn paycheck thing!)


Anyway, all of the parts are now home and painted. We started installing the fenders this evening and hope to put the cab on tomorrow evening. The roof ended up needing to be replaced as one of the previous owners made the wood himself and did not do a very good job. The doors were not fitted up properly due to the roof dimensions being off. That and all the pieces were straight, not curved as they are supposed to be. I bought a wood kit, which is going to take a bit of effort to fit up, but should be fun.


I am finding reassembly to be very slow as every piece you touch either needs to be cleaned, polished, repaired, replaced or painted. I cannot wait until it is done.


Belated happy Father's Day to all you Fathers out there.My son and I are having a lot of fun with this project.


Bob
 

Attachments

  • 068.jpg
    068.jpg
    68.4 KB · Views: 97
  • 069.jpg
    069.jpg
    71.8 KB · Views: 110
  • 071.jpg
    071.jpg
    71.3 KB · Views: 97
  • 074.jpg
    074.jpg
    62.6 KB · Views: 99
  • 076.jpg
    076.jpg
    83.1 KB · Views: 100
I think you used a spark lever rod to connect to the carb. Carb rod should be straight. The P.U. looks like it'll be a winner.
 
I have a 31 Coupe that You and Your Son could work on,,, Just trying to help!!!! I hate to see Your fun end!! Your truck looks fantastic.
 
Jim,

I looked back at my old pictures and that is the same carb rod I took off. Upon closer look, it is bent kind of funny. I also looked at other photo's of engines and see what you mean about it being straight. I'll have to get a new one.

Thanks!!
 
bobgreco said:
Jim,

I looked back at my old pictures and that is the same carb rod I took off. Upon closer look, it is bent kind of funny. I also looked at other photo's of engines and see what you mean about it being straight. I'll have to get a new one.

Thanks!!
Click to expand...

You can easily straighten the throttle rod, then bend the forged arm BACK where it should be. The forged arm is easily bent COLD, and I often see them bent ahead to the point where the carb won't idle down. I supose it bends during a careless engine removal, when the cross shaft hasn't been removed FIRST, as it should be.

Looks like you are moving right along on the truck and it's looking good!
 
You must log in or register to reply here.
Back
Top