Original body style???

Ayers1

Ayers1

Well-known member
I was at a cruise in this evening and this pick up was there. It's a 29 Ford street rod and I complimented the owner on the nice job of stretching the cab. He said it was never stretched and came like this originally and was marketed out west. I have never seen a 29 pickup body like this. Was the guy full of BS or is this a style I have never seen? Thanks!
 

Attachments

  • 20240615_163447.jpg
    20240615_163447.jpg
    87.9 KB · Views: 150
I hadn't thought about that. He did say the rear window was made bigger than original but that was supposedly the only modification.
Thanks!
 
Looks like the 6" extended cab corners that the vendors sold at one time.
 

Attachments

  • WEB-KIT-1185.jpg
    WEB-KIT-1185.jpg
    8.9 KB · Views: 19
Its a recent stretch.

We know Ford didn't sell it with that stretch and side window.

Most independent body builders would have purchased a chassis which would come with a commercial cowl (no A pillar) and no other body components. The pictured hot rod's full cowl, doors, and the lower rear panel all appear to be FoMoCo.

It doesn't make sense for an independent body builder to buy a complete pickup from Ford and then stretch the rear corners and resell. Looking at a lot of independent bodies of that era they are custom built from the A pillar to the tailgate.

And the dismissive "marketed out west"...thats the BS.
 
It's nice to know that I wasn't completely uninformed. Didn't know you could get cab corners to stretch the cab, although it does make sense to do it like that. So it most likely was an original cab with new corners. It was a very nice job. I figured the "sold in the midwest and beyond" was BS but I don't know everything about the A's production so I give the benefit of the doubt.
 
Ask away, it's the best way to end the old wives tales about these cars.

Here's a photo of a commercial cowl on the assembly line, you can see that the sheet metal ends at the gas tank. This is what an independent body builder would have started with.

544848
 

Attachments

  • thf115854.jpg
    thf115854.jpg
    59.9 KB · Views: 191
Also, the tailgate may be original but the box isn't, And pickup tail light was mounted under box, not on fender.
 
There were many custom body manufacturers at the time, that offered many different variations of commercial bodies for the Ford Model A.

Here for example is an extended cab pick-up offered by Springfield Commercial Bodies:
544854


....or this one offered by Martin Parry:
544855


There were hundreds of such extended cab commercial vehicles, in all type variations, that were available as aftermarket bodies for the Ford Model A and AA chassis.

Brad in Maryland
 

Attachments

  • IMG_3681.jpg
    IMG_3681.jpg
    45.2 KB · Views: 177
  • IMG_3685.jpg
    IMG_3685.jpg
    44.2 KB · Views: 180
When I was a kid, my pop would purchase grain bed bob tail trucks from Tradewind Industries. They had a shop in Liberal, KS that was close to us but they also had a shop in Wichita, KS. They were one of many companies that built custom beds for the Ford truck chassis. Fords 82A cab was small so those folks that had local body and bed manufacturers would buy from them to get a vehicle that was better for their needs.

My Grandpop purchased his grain bed trucks from a Local IHC dealer. He used the International Six Speed Specials for quite a few years. They had a larger box and better gearing for hauling full loads of wheat than anything else he could get locally during the late 1920s.
 
Last edited:
@rotorwrench, that's a great story! Back then you could get almost any configuration to suit your needs apparently!
 
You must log in or register to reply here.
Back
Top