NOS fender-unknown to me

Jack1937fordpu

Jack1937fordpu

Senior Member
City
Leland
State
NC
Price
??
:confused: More pictures of the fenders I have-Do not know what they fit or what year. They are NOS and they will not fit my 37 Ford PU. If you can recognize or have an idea about price, let me know. I have gotten one or two suggestions and I thank you for answering. Jack
 

Attachments

  • fender 3.jpg
    fender 3.jpg
    39.7 KB · Views: 116
  • unknown fender 4.jpg
    unknown fender 4.jpg
    46.3 KB · Views: 107
  • Unknown fender 5.jpg
    Unknown fender 5.jpg
    42.1 KB · Views: 113
  • Unknown fender 6.jpg
    Unknown fender 6.jpg
    46.3 KB · Views: 101
Hi A=Model Man,
Thank you for identifying the fenders. I will take a $1,000.00 for the pair plus shipping cost as I have this in them. I will also trade for 37 Ford PU rear passenger side NOS fender.
Jack
 
Hi hrdtlrdr,
I will take a $1,000.00 for the pair plus shipping cost as I have this in them. I will also trade for 37 Ford PU rear passenger side NOS fender.
Two people have identified these as fitting 39 Ford.
Jack
 
I just read your ad with great interest and went out to measure my very rusty '39 1/2 ton pickup front fenders. I took all of my measurements on the passenger side. So anyway here goes...the wheel well opening is approx. 31 inches. The length of the fender from the running board to the front of the fender is about 55 inches (bear in mind this is a running, driving truck so the tire was a bit in the way of the tape measure). The width of the square end that abuts the running board is about 12 inches. Also at this end there are three evenly spaced bolt holes to connect to the running board. Then there is one hole closer to the left corner and one a bit closer to the right side. A total of five holes as you view the inside of the fender from the front looking toward the back. Of course yours are off the vehicle and a bit easier to see. There are also a series of 8 holes along the inside edge where the inner fender panel and hood side studs run through the fender. To further confuse the issue I took another measurement across the fender about where the top bolt hole is for the headlight bracket and it measures 23 inches. This should help you verify the identity of your fenders and yes they will fit '38 and '39 Fords in the light truck category. I would also be interested in them if you haven't sold them yet. Sorry for being so long winded. Toby (802-869-2688) or e-mail me at jen.toby@yahoo.com
 
Hi Jack, I'm the guy that sent you the measurements for the '39 tuck fenders. Do you still have them? I am interested as I really need to replace mine. My phone number is 802-869-2688. My friend, Christopher Steele lives in Julian, N.C. and I usually come down once a year to visit. Please post something to let us know what you have decided. Thanks, Toby
 
You must log in or register to reply here.
Back
Top