noisy engine

J

joedaless

Member
Hi All,
What is a good additive to calm a noisy engine that runs great but has a little noise to it. The car is a 1956 Ford V8.

ANY AND ALL HELP WILL BE GREATLY APPRECIATED.

Thanks,
Joe D
 
thats a very loaded question? First you need to determine whats making the noise and repair the problem. There is no majic fluid the fixes engine. Frank
 
Frank is correct. Find out what it is or it may not be "that runs great" for very long. have you check the valve lash. Y-Block Fords had solid lifters and if not adjusted occasionally will get pretty noisy.
 
My '55 V8 had a banging noise on startup that would quiet down while driving...turned out to be flex plate rivets were loose. New improved light weight replacement flex plate from Tee-Bird Products cured that problem.
 
A big can of valve lash may fix it, but it may need more. Run the motor warm with the rocker covers off to see if you have oil coming out the little pipe on the right end of each side. If not, dont wast time adjusting things, you need to go deeper. If you have a good supply of oil, and it has been making noise a long time, chances are there is a groove worn in each rocker arm. That will make it nearly impossible to get an accurate adjustment. The book calls for .019. You can adjust them to .016 to try and take up some of the play. Any less may not be safe.
 
I found Him! it's too late! :eek:
 

Attachments

  • images.jpg
    images.jpg
    11.1 KB · Views: 14
My 56 Merc also had a noise at idle when started. Originally was told that it was the Torque Convertor lacking oil. After investigating, found that it was the Rivets holding the "fingers" on the Flex Plate. Took the Flex Plate to an Engineering Shop where they tightened the Rivets. Noise now gone.
Regards Mercman <><
 
You must log in or register to reply here.
Back
Top