New Edelbrock 94

[joe plumber]

Anyone heard anything about the 94 Edelbrock carb,good ,bad or otherwise

 

[baldmustang]

I put one on my 51 F1 flathead. Started up easy, runs great. Very Happy. Did not have to adjust. I bought it from Midwest. It was expensive $324.00

Unfortunately, I don't get to drive it much. Probably ran two tanks of gas through it so far.

 

[joe plumber]

The cheapest I have found so far is a a little over$400

 

[Ole Don]

Anything Edelbrock will be good. The name is on the part. The four barrels come with a book on how to tune, read it.

 

[TedEaton]

I put a trio of them on a warmed over 272 Y-Block. Due to camshaft being a bit on the wild side, the idle feed restrictions in each carb had to be reduced in size. Here's the link to the article that was published in Y-Block Magazine which goes into more detail on the modifications performed to the Edelbrock 94 carbs.
http://www.eatonbalancing.com/2015/06/05/hopping-up-the-272/
Ted Eaton.