Need Source for engine part common to 35-48

W

W1964

Junior Member
I need an Adapter (fuel pump mounting) pn 48 9415. It is mounted on the rear of the intake manifold. The fuel pump is attached to it and the oil filler/breather cap is on top. It's illustration is on page 214 of the "green book" and the pn is shown on page 420. Can you point me in the right direction? Thanks a lot. Bill
 
Be aware that the fuel pump push rod must match the stand. The main difference is whether the intake manifold is cast iron or aluminum. Aluminum type is 7.87", and the iron is 8.87", and are not interchangeable.
 
W1964 said:
Is the only difference the length of the rod?
Thank you.
Click to expand...

Just to clarify - the stands are the same height. The intake manifold makes the difference in which rod is required. As stated in the previous post, the factory aluminum intake requires the (1") shorter rod than the cast iron intake.
 
If your looking for 48-9415 as it was produced in 35 it is not reproduced. Ford changed the part appearance and did not change the part number. The later part is available as a reproduction and many originals are for sale on auction sites and retailers. The originals are a much heavier die cast without an embossed ring above the area where the fuel pump mounts as in the photo below.
 

Attachments

  • 35 fuel pump adaptor.jpg
    35 fuel pump adaptor.jpg
    39.7 KB · Views: 33
You must log in or register to reply here.
Back
Top