need some help on 34

M

Marshall

Member
I'm tring to fit the deck lid and I don't think the repop lower pan is right.
I would like to know the measurement of the rear tail pan and the upper
deck lid opening of a stock coupe . I would like to have them off more than one car .
Thanks
Marshall
 

Attachments

  • Mvc-004s.jpg
    Mvc-004s.jpg
    26.4 KB · Views: 42
Hi
Steve Real steel in Portland should have the correct piece because of their stampings from a digitially measured 34 coupe. I think there was issues with early repos that are not stamped.
 
The one I have is from steve's and I don't think it is right . I could be wrong , I just need to dubble check , most of the parts I got from Steve's
are right on the money.
Marshall
 
I think Steve had one for the roadster body but did a newer one for the coupe. Is yours the older version??? Either way please post your results becauseI have the same question.
 
Marshall said:
I'm tring to fit the deck lid and I don't think the repop lower pan is right.
I would like to know the measurement of the rear tail pan and the upper
deck lid opening of a stock coupe . I would like to have them off more than one car .
Thanks
Marshall
Click to expand...

Hey Marshall, I just measured an original one on my car. Its 38 1/4 inches long at the top.

Hope this helps...

Tim
 
Ok I measured my 33 3w coupe which is in bare steel and still has the stock panel below the trunk opening. Measured 38 5/8 at the top opening measured on the body because it is curved. 38 5/16 at the lower opening measured across the top of the lower panel following the curve.
 
You must log in or register to reply here.
Back
Top