Need 13/32" socket for the GAV housing.

C

ckulchar

Senior Member
Did a search and didn't find a thread. Remember a few years ago a thread that someone was furnishing them. Anyone have a source for one? New or used.
Thank you in advance.
Charley
 
Years ago I put my name down to the guy that was making some of those sockets but I never heard anything again.

Manuel in Oz
 
I have no clue where to go for a socket but I have some suggestions for a wrench. An 11mm open end wrench is tight but will usually fit by fileing a wee bit of material off the wrench, the box end of the wrench will not fit. What you really need is a 13/32” 6 point box end wrench. Very difficult but not impossible to find, turns out that the set screw fo a lathe tool post is/was 13/32” and those used a 6 point box end wrench. You can find them on ebay from time to time I have bought a few, I have never found a source for a new one. The most common manufacturer of the tool post wrench was Williams. If you look at a picture of the wrench it will look like the rim of the box end is too fat for the wrench to work but usually does. If needed you can grind a little waterfall off of the wrench.
 
The 13/32" 6 point box end wrench was available in UK a few years ago and also a regular open ended 13/32" "11/32" wrench . Good quality made by FACOM in France . The box end fits without a need to dress the end with a file .

John in Suffolk County England .
 
Good Morning...I would bet that NAPA can order you one if they don't have one. Another place to try would be Amazon...a third might be Renner's Corner...as they supply lots of small parts for carburetors...most likely a quarter or three eights drive...Ernie in Arizona
 
I remember the post, and in-fact ordered one and it's sitting on my desk as we speak! I saw it under some papers and thought I must have ordered it and it must be Model A and I just looked at it and sure enough it is 13/32 and I think I also have one they used to sell that's a deep well socket with a T on the top, that's the one I use all the time. I would think searching for the thread it would come up?
 
I actually bought 3 of the HAAG 13/32" sockets. Gave 2 of them to friends, still have one in my tool box.
 
There are two sizes, 13/32" and 7/16". Lawson Products carries a 13/32" six point, deep socket in 1/4" drive. Minimum order is $50, and you have to register to become a buyer from them. I went through the hoops and purchased 10 of them. Cost is about 5 dollars each. Hope to receive them next week some time. If anyone is interested in getting one of these from me, please text me at 509-220-4346.
 
ckulchar said:
Did a search and didn't find a thread. Remember a few years ago a thread that someone was furnishing them. Anyone have a source for one? New or used.
Thank you in advance.
Charley
Click to expand...
ckulchar said:
Did a search and didn't find a thread. Remember a few years ago a thread that someone was furnishing them. Anyone have a source for one? New or used.
Thank you in advance.
Charley
Click to expand...
13/32 martin wrench ,also all over search on line for socket
 

Attachments

  • 1332 martin wrench.jpeg
    1332 martin wrench.jpeg
    63.4 KB · Views: 8
  • carbs.jpg
    carbs.jpg
    92.6 KB · Views: 7
Last edited:
You must log in or register to reply here.
Back
Top