moderd seats

M

mrob

Junior Member
Due to health problems I need to install modern seats in my 4 door (power would be best).Any suggestion as to what will fit? Thanks
 
Last edited:
If you're installing modern seats, you might want to also think about adding seat/shoulder belts at the same time. There are several posts on the forum to give you ideas.

Glen
 
mrob said:
Due to health problems I need to install modern seats in my 4 door (power would be best).Any suggestion as to what will fit? Thanks
Click to expand...

Whereas all the others are giving you the runaround, I can tell you what I did.
I used 90's era Honda Prelude seats. They are narow enough to fit 2 in the front easily.
They are 6 way adjustable but not power. Later model may be. The thing I like about them is they have adjustable kidney pads on the side.
Another nice thing is the original front mounts can be used. You will have to fab rears.
I can change back to the original seats in 15 minutes.
 
Pete said:
Whereas all the others are giving you the runaround, I can tell you what I did.
I used 90's era Honda Prelude seats. They are narow enough to fit 2 in the front easily.
They are 6 way adjustable but not power. Later model may be. The thing I like about them is they have adjustable kidney pads on the side.
Another nice thing is the original front mounts can be used. You will have to fab rears.
I can change back to the original seats in 15 minutes.
Click to expand...

What run around? I gave him a link to seats that Bill has in his car and a suggestion that he contact him. Is that a run around? :confused:

Bill, I did the search and cannot find your post on where you found the parts and how you assembled them.
 
Last edited:
I haven't had COFFEE yet, but I'll try:
They're replacement Bar Stool Seats, mounted on 3/4" plywood panels. Under them are swivel mounts I found @ Bass Pro Shop & they fit the built-in seat nuts perfectly. Bottom panel has a piano hinge, at the front, mounting it to the seat riser, allowing the seats & panel to open up to the tool storage area. Gregg, (RIP) mounted an adjustable length bicycle kick stand under it, to hold it open.
They gave me QUITE a lot of extra leg room & I sit about 3 or 4" lower.
Also gave a lot more room to get your feet in past the "A" post, as it doesn't hang over the seat riser, like the wood spring platform did.
NO BODY mods & can be changed back to stock seating in about 10 minutes.
To get more room to get his feet in, with stock seats, one Guy cut off about 4 or 5" from the front of his seat platform & his springs. (Of course, that DIDN'T give him more LEG ROOM.)
Bill W.
 
Last edited:
Here's Bill's seats:
 

Attachments

  • 5-29-2012 10-26-43 AM.jpg
    5-29-2012 10-26-43 AM.jpg
    46.6 KB · Views: 60
  • 5-29-2012 10-27-05 AM.jpg
    5-29-2012 10-27-05 AM.jpg
    47.4 KB · Views: 53
You must log in or register to reply here.
Back
Top