Can anyone tell me what a cast iron puller with KMODET over T204 cast on the side of it pulled. The body is 2 1/4" in dia. with one side left open to receive whatever is being pulled. Bottom has a one inch open slot to receive whatever is being removed from larger part above. Top is a solid hub with a 1/2" bolt tapped through it to push something through the part inside main body. Hex on bolt is 3/4" with hole through hex for a sliding rod handle. I cannot come up with good use for it. Thanks
Model T puller
- Thread starter t.soseman
- Start date
yachtsmanbill
Well-known member
model A on top or model T wire wheel hubs below... ws
Sorry cannot send picture because of no digital camera and not knowledge of finer points of computers. I must guess that it's not a hub puller because a 1" slot will not go over any model A hub I've ever seen ant the reach of 1 3/8" is too short. Could it be a generator drive gear puller? Just a guess cause I'm a model A person.
yachtsmanbill
Well-known member
Pitman arm puller too... Buy the $100 digital camera... you wont regret it! ws