model a frame dimensions & identification

Manager said:
I have it and the Wescott plan and there is a fair few differences in the measurements but which are correct I don't know.:confused:
Click to expand...

I'd think there is 2 was to check the prints..

1. Get the Ford frame dimensions (print) for the locations..
2. Measure a known/good/ correct frame...
 
Randy in ca said:
Here's another frame dimensional diagram that I saved from somewhere - I've hardly looked at it, so can't comment on the accuracy of the shown dimensions.
Click to expand...

Randy;
I checked a GOOD, known frame that is flat, and measures GOOD for "diamond".
Most all of the measurements fore and aft are not even close, the measurements left too right look close. So I don't consider this print good for checking a frame...
I'd like to find a Ford print,...anybody have one?


http://www.fordbarn.com/forum/showthread.php?t=64608&highlight=frame+dimension&showall=1
 
You must log in or register to reply here.
Back
Top