Model A Back Cowl Mounting Screws

S

ssals@att.net

Junior Member
Are the rear hood mounting screws secured with machine nuts? The screws go at a slight angle and terminate in a hard to reach area between the firewall and gas tank.

Are the nuts accessed by hand in-between the firewall and gas tank, or do the screws grip with what's in-between then firewall and gas tank?

Synder's catalog shows the rear hood mounting screws sold as a set of two on page A-163. Nuts are not depicted, leading me to believe nuts are not used.

Any ideas? Please Help!
 
ssals@att.net said:
Are the rear hood mounting screws secured with machine nuts? The screws go at a slight angle and terminate in a hard to reach area between the firewall and gas tank.

Are the nuts accessed by hand in-between the firewall and gas tank, or do the screws grip with what's in-between then firewall and gas tank?

Synder's catalog shows the rear hood mounting screws sold as a set of two on page A-163. Nuts are not depicted, leading me to believe nuts are not used.

Any ideas? Please Help!
Click to expand...


Yes, however the nuts are "cage nuts" meaning they have a small sheet metal strap around them to hold them while you install/remove the machine screw.
 
My cage broke and one nut escaped. With a young helper holding, I believe, a 12-24 nut up between the tank and firewall I could get the screw started and tightened.

Sewall Tyler
 
I believe you are going to have to remove the gas tank to install the cage nut. If the tank is out I would use Brattons PN 22392.

Sewall Tyler
 
You must log in or register to reply here.
Back
Top