Leatherback rear carpet question

[david801]

I have ordered the carpet and upholstery from Lebarron Bonnie for my 1928 Leatherback. They sent a brown paper pattern for the rear carpet so I can check and see if it would fit. Instructions said to trim or add to the pattern where needed. There were a few minor areas where I did this but there is a larger area on both sides of the car, just inside of the center pillar, where there is a larger area that is not covered by any of the carpet pattern pieces. See picture.
Can someone send me a picture of this area in your car?
There are 3 pieces of the pattern that meet in this area, which one covers this spot?
I have contacted LB twice about this and have not heard anything back yet.
Thank you.
David

 

[Roadster62]

I'd check with LB to be sure your pattern is just for checking and not the master pattern, otherwise maybe you need to make a very accurate one. Bob

 

[david801]

Any suggestions?

 

[supergnat]

Hi Dave801,
I have a 28 Leatherback with the original interior. Here are a few photos. Let me know if you have any questions or need any other views.
Supergnat

 

[david801]

Very helpfull pictures, thank you!

 

[david801]

Supergnat, could you take another picture from the same direction as picture #1 or #5 but can you lift up the piece of fabric that goes along the lower part of the seat back so I can see how far the carpet goes under the front seat?
Thanks again.

 

[supergnat]

I took a few more photo. I cannot pull the carpet back easily since the seat belt anchor bolts pass through it. The floor carpet piece extends under the front seat carpet trip piece by about 1 1/4 inches as you can see in the photo. I have labeled the photos (hope this works).

001 - Floor carper fastener
002 - Floor carpet under trim piece
003 - LH pillar trim piece
004 - Rear seat kick cover piece
005 - RH pillar trim piece
006 - RH rear frame trim piece
007 - Carpet trim piece - rear of front seat

Let me know if you need any more photos.
Supergnat