KR Wilson engine lifting bracket

B

BlueNotes

Senior Member
I recently scored a repro KRW engine lifting bracket but the 2 knurled pins are missing. Can anyone advise the measures (or a simple drawing) for the pin so I can make them?
 

Attachments

  • KRW 6000.jpg
    KRW 6000.jpg
    113.1 KB · Views: 237
The pins are .500 x 2.375 that fit into the bracket and have a .750 x .500 length head. The over all length is 2.875 including the head .
A picture and let me know if I can help as I have a machine shop
 

Attachments

  • image.jpg
    image.jpg
    31.6 KB · Views: 274
hop up said:
The pins are .500 x 2.375 that fit into the bracket and have a .750 x .500 length head. The over all length is 2.875 including the head .
A picture and let me know if I can help as I have a machine shop
Click to expand...
Thank you very much @hop up! That's all I need to make them. :)
 
It fits in the valley and the two pins drop inside the heat risers.
 

Attachments

  • KR WILSON 6000 E .jpg
    KR WILSON 6000 E .jpg
    35.3 KB · Views: 218
Tim Ayers said:
Yep. I believe you can flip it 180 degrees to have the motor angled either forward or back, right? The offset changes the angel the motor will hang.
Click to expand...


Tim from my experience using the KR Wilson one I have if its turned around the lifting bracket will not sit flat on the inside surface of the valve chamber.
Ronnieroadster
 
I got this one off ebay and works great.
 

Attachments

  • Prep1.jpg
    Prep1.jpg
    50.6 KB · Views: 118
  • Assembly10.jpg
    Assembly10.jpg
    49.5 KB · Views: 111
Ronnieroadster said:
Tim from my experience using the KR Wilson one I have if its turned around the lifting bracket will not sit flat on the inside surface of the valve chamber.
Ronnieroadster
Click to expand...

Ahh. Interesting. I don't own one, but I've thought that's how it worked. Thanks for setting me straight. I've been on the hunt for one for years. They've all seem to have disappeared.
 
You must log in or register to reply here.
Back
Top