It's been a good dayđź‘Ť

VFRhugh

VFRhugh

Senior Member
I can see light at the end of the tunnel.
 

Attachments

  • image.jpg
    image.jpg
    62.6 KB · Views: 517
So that's what you do after putting the motor back in the car!

I have been trying to figure that out for a few weeks!
 
Still have a little way to go before hitting the road. While I have the floorboards out I'm going to try to shim the body so the doors fit better.
Hugh
 
First I-10 adventure.
I now have about 250 miles on my counterbalanced engine project. I can get almost everything I need in my little town but today I needed a boat part in the next town. It's only an 11 mile trip but I have to run down I-10 for a couple of miles before I can get back on the feeder road. It didn't hurt that traffic was light:) Also got a lot of positive attention from the 18 wheelers.
Hugh
 

Attachments

  • 7DB09B33-A860-419D-8BFB-164ED2CB7369.jpg
    7DB09B33-A860-419D-8BFB-164ED2CB7369.jpg
    48.7 KB · Views: 91
I have a Mitchell 1.26% OD so it's only turning about 2200 RPM & it was only for 2 minutes. This engine is very happy between 1750-2200 RPM.
Is there a way to tell if my coil is oil filled or should I assume it is and turn it over?
Hugh
 
VFRhugh said:
I have a Mitchell 1.26% OD so it's only turning about 2200 RPM & it was only for 2 minutes. This engine is very happy between 1750-2200 RPM.
Is there a way to tell if my coil is oil filled or should I assume it is and turn it over?
Hugh
Click to expand...

PM sent
 
You must log in or register to reply here.
Back
Top