intake manifolds

[aussie merc]

question for the learned looking for a duel carb manifold with a throttle spread of at least ten 10 1/2" inches suit pre 8ba 24 stud

 

[Bored&Stroked]

I'm not back at home in Ohio, but I would think that a variety of "racing style" 2 carb manifolds would work out ---> Navarro, Edelbrock, Sharp, Offy, etc..

You won't have room to mount a generator in front (you'll need to make an idler) - is that what you're looking for? I can measure a couple when I'm back home in a week or so?

 

[Ronnieroadster]

That's the widest center line you would find. Measured two Shuter Sports Australia just learned the intake is from New Zealand and Edelbrock Super both have 10-1/2 inches throttle center line both are pre 8BA.
Ronnieroadster

 

[KiWinUS]

That's the widest center line you would find. Measured two Shuter Sports Australia and Edelbrock Super both have 10-1/2 inches throttle center line both are pre 8BA.
Ronnieroadster

Interesting manifold Shuter Sports Manifold you have Ronnie. Made in New Zealand not Australia to the best of my knowledge by Frank and or Rod Shuter legendary racers and hot rodders from Christchurch New Zealand.

 

[KiWinUS]

Duplicate

 

[Ronnieroadster]

Interesting manifold Shuter Sports Manifold you have Ronnie. Made in New Zealand not Australia to the best of my knowledge by Frank and or Rod Shuter legendary racers and hot rodders from Christchurch New Zealand.

During my years of collecting Ford flathead intakes I was able to add intakes made in other country's. The Shuter Sports was one of the rare finds there's also a number of other interesting intakes from Australia I was able to add to the variety of what was once available for the flathead Ford V-8.
Thanks for the correction.
Ronnieroadster

 

[aussie merc]

side mounting the gen is not a problem looking to get the carbs over the port groups but still be able to use wet air cleaners correct to the era hence the ten inch spacing also would consider using a 3x2 manifold and capping the center mount