Installing Starter motor

Thx Chap52, case is seated fully no gap so I’m good. As it’s on secured on my bench already I’ll make sure it runs to b sure. It only had approx 2000 miles on it so I’m sure brushes r good. Ran /started car great before removal.
Thx all for the help!
 
I found the three hand difficulty was largely due to having to hold 20# with a weakening arm hold, then trying to wiggle the starter into place.

I built a starter holder using an old scissor jack - see my post here somewhere with photos titled "I Just Installed My 20# Starter By Myself - Easily - $4 Tool"
A search will find it.
 
Here are the photos:
 

Attachments

  • eStarterTool.jpg
    eStarterTool.jpg
    36.7 KB · Views: 43
  • eStarterToolwStarter.jpg
    eStarterToolwStarter.jpg
    33.1 KB · Views: 44
  • eStarterToolDone.jpg
    eStarterToolDone.jpg
    54.8 KB · Views: 51
19Fordy

I didn't do anything but install the "stump puller" in 02/2011 so I don't know the answer to your question. It has been working fine though. I still have the old starter to use if I ever need to.

Robert/Texas
 
Overkill-F1 said:
Is the black part that is attached to the jack, a plastic ABS fitting.? It looks like a coupler for (4"?) ABS pipe?
Terry
Click to expand...
I don't know, I just posted the photos, Paul built it. I can look back at his original post.

"If you have a sissors jack (and who doesn't) buy a 4.5" plastic disposal pipe joint (ABS perhaps) for about $4 at any hardware store. The starter is 4.5" diameter as is the ID of the joint you purchase. It has a raised rib inside soas the pipes it joins are centered. Remove this rib with your dremmel or equivalent tool, then cut a minor section from the pipe joint. More than half but less than 3/4 (see pic). Fasten the 60% part (tossing the 40% part) to the top of the jack. I drilled and tapped for 6-32 screws. The starter will snap into the holder atop the jack. When done you can remove the screws and easily store the pipe section."
 
JSeery said:
I don't know, I just posted the photos, Paul built it. I can look back at his original post.

"If you have a sissors jack (and who doesn't) buy a 4.5" plastic disposal pipe joint (ABS perhaps) for about $4 at any hardware store. The starter is 4.5" diameter
Click to expand...

JSeery,
Thanks for looking that up, seems like a good idea.
Terry
 
I liked the scissor jack idea & kinda used the idea modified to what I had w a small rolling hydraulic jack. Drilled holes in the lift cup & used 14 gauge house wire stripped to attach starter to cup on jack. Worked good. Took weight off the 70 yr old arms & back:D! Was able to get height right raising & lowering & easy to angle & jiggle gear past ring gear. After starting bolts & snugging snipped wire & pulled them out.
Thx for the idea, will stay on my trick list:)
 
You must log in or register to reply here.
Back
Top