I Need Help Please with some repair advice

L

Lamar Green

Junior Member
Replaced ignition switch on my 31 Model A Roadster and now the car will not start (it started before with the old one)

I have spark at the points and then smoke is coming out below the point set inside of the distributor for some reason.

Can someone help me with the wiring route from the switch to coil to distributor not sure if I've crossed something or not....

Any help would be greatly appreciated, thanks!
Lamar Green is online now Report Post
 
"Sounds" like you may have the wiring correct but the ignition cable has been screwed into dist. body a bit too far and bent the contact inside. You'll need to remove upper dist. plate to get at the bent contact and straighten it out a bit. Then should redo the timing, since the cam needs to come off. Hope this helps.
 
Take heed of these slides:
 

Attachments

  • Slide1.jpg
    Slide1.jpg
    69 KB · Views: 79
  • Slide2.jpg
    Slide2.jpg
    61.5 KB · Views: 72
  • Slide3.jpg
    Slide3.jpg
    71.9 KB · Views: 66
Um,... if you have smoke coming out of the distributor it needs more than the timing reset. You need to pull that distributor apart to see what is going on.

A fuse block mounted at the starter will prevent all the smoke from coming out of your wires. They only put so much into them and once you let it all out things don't work anymore.
 
The wires on the back of the switch can ground out on the gas tank, I solved this issue by using several layers of electrical tape behind the switch on the gas tank.
 
You must log in or register to reply here.
Back
Top