I have to have this part!

[SlickScott]

Saw this cover on YouTube from a guy in Italy. I have to have this! Anyone know where I can get one please? I have searched for weeks with no leads. Even Charlie Yapp was asking, but he doesn't speak Italian and neither do I.

 

[mercman from oz]

Wanted - Cover like this? Any ideas? SlickScott

 

[700rpm]

Where does it fit?

 

[updraught]

It goes on the side of the engine under the water inlet. Think they are made by a guy here in Oz.

 

[pbishop]

I would LOVE to have the 'part' as well. Let us KNOW if and when you can find it. Post in under the SAME heading, or - 'GOTTA HAVE this PART'.

 

[jukenut 16]

Available at www.trademe.co.nz search for engine cover, vintage car parts.

 

[jukenut 16]

They are Geraldine Auto Restorations In NZ. Also on facebook?

 

[updraught]

They seem to have been made by Terry Wills (I think now deceased) previously, try
https://www.oldtimespeed.com.au/shop

 

[aermotor]

Saw this cover on YouTube from a guy in Italy. I have to have this! Anyone know where I can get one please? I have searched for weeks with no leads. Even Charlie Yapp was asking, but he doesn't speak Italian and neither do I.

I want also and a matching valve cover.

John

 

[jimTN]

https://www.trademe.co.nz/a/motors/...parts/engines/listing/3270149199?bof=Hnze4uka

 

[aermotor]

https://www.trademe.co.nz/a/motors/...parts/engines/listing/3270149199?bof=Hnze4uka

Any state side suppliers? John

 

[Bob C]

Any state side suppliers? John

Go to the bottom of the link in post #8 and it shows two
USA distributors.

 

[SlickScott]

Thanks so much to everyone! I literally have been searching for weeks...

 

[duke36]

May need mod's due to covering Engine No. if used for local DMV registration.

 

[Oldbluoval]

If you can make a wooden one you can likely get it cast in aluminum.
I know that sounds like a wild thing but I get pieces cast often in aluminum and bronze.
Harder to get short runs than it used to be …everyone is behind these days it seems

 

[Chris Haynes]

Available at www.trademe.co.nz search for engine cover, vintage car parts.

That search doesn't find it.

 

[Neil Mylar LakewoodCA]

Is there any kind of reaction when you use an aluminum side cover on a cast iron block?

 

[alexiskai]

Is there any kind of reaction when you use an aluminum side cover on a cast iron block?

Aluminum would react with stainless steel, but not cast iron – and anyway, the block should be painted, so the only points of contact would be the fasteners. So don't use stainless steel bolts.

 

[jukenut 16]

That search doesn't find it.

Sorry, the listing on Trademe NZ had just closed. They can be asked to relist if required?

 

[Karl]

Sorry, the listing on Trademe NZ had just closed. They can be asked to relist if required?

Trade Me won't allow overseas bidders -Karl