Holley 94 vacuum line fitting

J

JHFORD51

Senior Member
Guys,
Is there such thing as an oversize brass fitting for the vacuum line connection on a Holley 94 carb as used on 48 and up truck motors and 49 up car motors? This is the port for the hard line going to the advance can on the distributor.

My port looks fine, threads look good, but none of my three good hard lines with associated brass fittings thread up. Its like the port and threads in the carb are one size bigger than normal.

This is on a spare carb I just had rebuilt. Ofcccourse I only noticed when I went to install the carb...

Thanks in advance.
 
Are you sure you have the correct fitting on the line? New ones can be had from NAPA, although not usually stocked.
 

Attachments

  • Ford CarbVacNut.jpg
    Ford CarbVacNut.jpg
    46.1 KB · Views: 90
if it is not the one ross showed then as tinker said somebody has monkeyed with it.good luck as you know that has to seal tight.
 
Can you carefully repair the over size hole with JB Weld?
Sounds crazy but could you use Teflon tape or RTV sealer on the fitting?
Could you first insert a very thin piece of thin walled plastic tubing with some Permatex sealer in the hole and then screw in the OEM fitting a little at a time making the threads as it goes in ?
 
19Fordy said:
Can you carefully repair the over size hole with JB Weld?
Sounds crazy but could you use Teflon tape or RTV sealer on the fitting?
Could you first insert a very thin piece of thin walled plastic tubing with some Permatex sealer in the hole and then screw in the OEM fitting a little at a time making the threads as it goes in ?
Click to expand...

Actually, "Loc-Tite" makes a product just for repairing stripped threads. It is an epoxy and comes with a small tube of a release agent, that allows you to get the joint apart after the epoxy hardens. I used it to repair some stripped threads (temperature sending unit) in the aluminum intake manifold in my Corvette shortly after I got it in 1987 and it's still holding. Unlike most products, it's probably better now then it was then, given the advances in chemistry.
 
Or you can send "Charlie ny" a private message on the Barn and see if he has a spare bowl for your carb.


Sal
 
You must log in or register to reply here.
Back
Top