Help I’m Lost

Re: Help I’m Lost

Lanny said:
===============================================

Hey Denny, do have a condenser that fits this young guys '34 ?

.
Click to expand...


Although I have sold a bunch to guys who have used them on "Helmets", "Crabs", and "Rabbit-ears" with consistent success, most folks consider them too costly for general use (and they are right).

However, if he continues to have trouble, I would consider sending him one "on approval" to see if it helps. The postage would be the limiting factor here.

As a matter of fact, I am going to discontinue making them when my current stock of components runs out. The price of brass and electronic components has gone through the roof lately.
 
Re: Help I’m Lost

I plan on contacting skip and sending him my coil and asking him about the condenser and ballast resistor like you said Lanny. Tinker, I have checked the connections on my battery they are good but I have replaced the positive ground cable because of the wire heating up, after the new cable was put on it no longer got hot. Again thank y’all for the help!
 
Re: Help I’m Lost

Lanny said:
===============================================

Here is some Skip Haney info for you...:)

Click on picture to Enlarge. ;)
Click to expand...

Does anyone know if this is still the correct information? I tried to call the “day” number it did not ring.
 
Re: Help I’m Lost

In your 1st post here, you say that you installed a rebuilt dist.
Was it rebuilt by a competent rebuilder, or picked up at a swap
meet, OR ???
The points in the dist must be set exactly, for it to work right.





.
 
Re: Help I’m Lost

Lanny said:
In your 1st post here, you say that you installed a rebuilt dist.
Was it rebuilt by a competent rebuilder, or picked up at a swap
meet, OR ???
The points in the dist must be set exactly, for it to work right.





.
Click to expand...

It was sent of to a builder and was rebuilt and as far as I know set up correctly.
 
Re: Help I’m Lost

34 fordor owner said:
Does anyone have a good recommendation of where to get a good coil for a dome distributor?
Click to expand...

Send your coil to Skip Haney in Florida to get it rebuilt better than new. He can furnish a proper condenser at the same time. About $80.00 plus the ride, but I'm not pricing his service by any means.
 
Re: Help I’m Lost

Alright guys, got my coil back from skip today and it looks great! I do need a new condenser though. Does anyone have good suggestions for condensers for the “dome” style distributor?
 
Re: Help I’m Lost

34 fordor owner said:
Alright guys, got my coil back from skip today and it looks great! I do need a new condenser though. Does anyone have good suggestions for condensers for the “dome” style distributor?
Click to expand...


On post # 61, tubman (Denny) may have one. PM him, he's a good guy.


Or you could try: Third Generation Automotive, Michael Driskel
at 844-327-5988 tomorrow.





.
 
Last edited:
You must log in or register to reply here.
Back
Top