K kurt v Well-known member Mar 7, 2026 #1 what should the push lift be, i have about 5/16" is that enough ? thanks kurt
SHORTDOOR Junior Member Mar 8, 2026 #2 I believe I measured about a 1/4 inch on mine. Sand the base of the stand flat and use the thin gasket under it. Also make sure your push rod ends are not worn.
I believe I measured about a 1/4 inch on mine. Sand the base of the stand flat and use the thin gasket under it. Also make sure your push rod ends are not worn.
Bored&Stroked Well-known member Mar 8, 2026 #3 kurt v said: what should the push lift be, i have about 5/16" is that enough ? thanks kurt Click to expand... That seems about right . . . as long as you have the correct push-rod, you should be good to go.
kurt v said: what should the push lift be, i have about 5/16" is that enough ? thanks kurt Click to expand... That seems about right . . . as long as you have the correct push-rod, you should be good to go.
B Bruce_MO Well-known member Mar 8, 2026 #4 I recall the lift is supposed to be 0.20”… a bit less than 1/4”.
