Flywheel VS a v-8 clutch

Does anyone remember which set of dimensions had a critical error? I don't remember which set it was only that there was an error.

Charlie Stephens
 
This is what the guy used that drilled mine.
 

Attachments

  • clutch diagram bolt.jpg
    clutch diagram bolt.jpg
    15.3 KB · Views: 112
I was thinking the same thing that one set of prints were flawed. I think that someone emailed me the corrected version at one point, but it would not print in a manner that showed all of it on one sheet. I would have to dig in old emails to find it. Rod
 
i think it's the flywheel lightening drawing from secrets magazine that you are referring to that has the error.
 

Attachments

  • LIte Flywheel print-ware red dim....jpg
    LIte Flywheel print-ware red dim....jpg
    70.6 KB · Views: 74
Would I be able to purchase a copy of your print? I'm not able to clearly read the one on my screen. I'll send the fee up-front. Thank you very much, Jim Robbins 703 Foothill CT. Boulder City, NV. 89005
 
Jim, the question I would pose for you is how are you going to drill these? I personally use my mill's DRO to find the X & Y coordinates, yet James Rogers uses his rotary table on his mill to drill them. Both work well but we really need to know which method you plan to use.
 
BRENT: I could do either, I have a Bridgeport DRO,& a 15" rotary table. Which can be supplied? Jim Robbins 703 Foothill CT, Boulder City NV. 89005
 
You must log in or register to reply here.
Back
Top