Float-a-motor...

R

Raven

Member
A couple of weeks ago I asked for some advice on how to get the hand crank to mesh with the rachet pully as the front motor mount springs are too thick and cause the engine to tilt upward. Some one on this site provided a link to a vendor that supplies a more factory stock spring set but the link has disappeared...could they possibly post it again? Thanks...
 
As you found out,some of the repop springs are too long.When the front mount is tightened to where cotter pin can be installed, the hand crank should line up with the ratchet & the springs should not be coil bound.
 
You must log in or register to reply here.
Back
Top