F-1 New wiring harness help

chudm71

chudm71

Member
My 1950 F1 is getting a new harness original cloth style, and I am at the point of replacing the headlight wires. I have the crossover wire but the old harness was butchered and I am sure there is a junction box I am missing. I have seen the one's at Mac's and Dennis Carpenter. I was wondering if this is what you guys are using also. Any Help would be appreciated.

Thanks.
Chad M.



This is the one from Mac's
http://macsautoparts.com/ford-picku...ack-fdt-14448-a/camid/FPU/cp/OQ0HAAA81000086/
 
I rewired mine with the Dennis Carpenter set up, and I don't have that junction thingy in the link you posted. I'm still running 6V if that makes any difference.
 
The 48-52 trucks did not use any connectors like that. Those are for passenger cars. The wires join together with a bullet conector. It's basically a small tube about an inch long with a black rubber coating. THe harness ends have male ends and the plug into the connector. Mac's new catalog has them listed on page 248, part number A 14487 for .45 cents each, They also show the 4 way that expands from one wire up to 3 more. Part number 59A 14487 @1.75 each. Your old harness may have a few examples still there. They may look like they're attached to one side, but they will pull off. All the repo dealers have these.
 
You must log in or register to reply here.
Back
Top