Engine vibration sanity check

Also I see you are running a cut down fan which is obviously out of balance ,You need to address this as you will likely destroy the bearings and your new walker radiator ,
 
Thx Shu47.
FlatheadTed the fan is stock with smaller dia. 4 blade used on the smaller 60hp version flathead. With the way the engine set-up turned out it was the only early ford fan I could fit between / under the radiator and cooling tubes. I'll figure out a way to check it but am pretty sure it is as balanced as stock gets.

Ross, I'll check on finding a stock generator bracket and see if I can that to work, in the mean time I'll see if I can figure out a support feature for the rear of the Alt.
 
OK .I did a Generator for someone recently and the fan was not seated correctly on the machined boss ,he had done two rear bushes at that point ,
 
Concentrate on lowering the whole deal. Find a way to support the back. My guess is it's going to "wag" if you don't. g
 
You must log in or register to reply here.
Back
Top