Engine Chirp is gone

Bob Johnson

Bob Johnson

Well-known member
Replaced the head gasket and noise is gone. Here is a picture of the old gasket. I installed this gasket about 14 months, 5000 miles ago.

Bob
 

Attachments

  • head-gasket01.jpg
    head-gasket01.jpg
    129.9 KB · Views: 177
Bob. Too me it looks like you may be running the engine abit too lean. Hard to say for sure in the pic. Rod
 
looks like the head needs to be milled, check the block also they do warp, and retorque as many times as necessary to get the head nuts tight


"QUOTE" SECOND PLACE IS NOTHING BUT THE FIRST LOSER
 
an opportunity?

seems like there's a real need for head gaskets with a little more meat between 3-4 and 1-2. with many engines sleeved back to standard it's a pity the gasket makers can't supply one.
is it too expensive to tool up?
 
Last edited:
either the head wasnt torqued enough times or the head is warped, double check the head before putting it back on, its extremely important to retourque head after every run till the head nuts quit moving, put a t square on the block and see what you have, and the head can warp in a few thousand miles if its not properly torqued, not looking to argue with you on this but i have seen it happen
 
The head was milled before the gasket was put in 14 months ago. I re-torqued the head about five times until it did not need anymore re-torquing. I checked the head after the gasket failure and it was still flat. The block, however had and still has places that are off by about 0.003". I do not want to resurface the block at this time.

Bob
 
ok here is where im going to called an idiot, but if the block is warped and it is in the middle, torque the middle head nuts pretty tight first, then torque the rest as usual, what you want to do is warp the head in the middle first to get it to conform to the block, what you have is a compression leak, gases working there way from one cylinder to another because the gasket isnt holding,(warped head or block) put 5 or 10# more torque on the center bolts
 
Close up view of gasket

Here is a close up view of the area that failed. Perhaps it might be helpful in figuring out what happened.

Bob
 

Attachments

  • head-gasket02.jpg
    head-gasket02.jpg
    49.1 KB · Views: 32
combustion gas leak from one cylinder to another, warped head, block or not torqued properly enough times or not torqued tight enough, find the reason before putting it back together, if you dont it will happen again, if it were mine i would have the head resurfaced or at least check at the machine shop
 
is that a Felpro or a Best? I blew a Felpro with the white filler in that same spot on a 5.9 Brumfield. The white filler is not too strong. A bit too much spark advance and the pressure blows the center out. The Best gaskets are filled with a black substance that seems to be holding up well. I had one on a decked block with a milled "B" marked head with 6:1 compression and it held up until I needed to pull it for a valve repair 20K later.
 
Hi Bob It is Tom in Napa, you will probably have to replace your head gasket from time to time until you are willing to have your block decked, flat and round are the key to a good running engine. call me if you would like to pro and con this a little.
Thanks Tom F
 
Bob, might call around and see if you can find a Felpro 7013-R1. Surely someone has a couple of them rat holed. Rod
 
You must log in or register to reply here.
Back
Top