Someone prior to my ownership put 40 brakes on my 33 coupe, the problem is after installing a new master cylinder and bleeding the system, fluid leaks from the vent hole in the cap (squirts from it) after pumping pedal. (looking back I think the old master cyl was probably ok cuz it was doing the same thing which is why I replaced it) Stock pedals in place putting cylinder in floor, maybe too low, below wheel cyls? (check valve) Anyone run into this before?
early ford juice brakes
- Thread starter offy19
- Start date
Peterooster
Member
Two items come to mind, air in system or more likely brakes need adjustment. Pete
On my Pontiac, if the level of the fulid is to high, it will come out the vent, but stops after it gets a litter lower. When the piston moves forward it has to move past a port, untill it does it shoots fluid back into the reservoir, and that's when it came out the vent on mine.
I did not bench bleed the master cylinder but when the brake fluid gets down about 1/2" from cap it stops leaking like "oldscouts" Pontiac, but I've never had this problem before so I'm going to re-bleed the system and re-adjust the shoes. I'll let you know what happens. Thanks for the input.
Charlville
Senior Member
I'm with Bader, the only problems of this nature I've had is when the master cylinder wasn't bench bled.
V8 Bob
Well-known member
It is perfectly normal for fluid to squirt when initial movement of the piston causes the compensating port to be closed off, trapping fluid in the cylinder. All masters I have ever had any experience with have an expanding gasket that completely seals off the fluid from the air vent, and would prevent any fluid loss through the vent. Didn't the Lockheeds also have a similar gasket? If not, they should. 
rich b
Well-known member
It is perfectly normal for fluid to squirt when initial movement of the piston causes the compensating port to be closed off, trapping fluid in the cylinder. All masters I have ever had any experience with have an expanding gasket that completely seals off the fluid from the air vent, and would prevent any fluid loss through the vent. Didn't the Lockheeds also have a similar gasket? If not, they should.
No, just a simple baffled vent, like the EIS replacement cap pictured.
Attachments
Talkwrench
Well-known member
DONT bench bleed single circuit master cyls..
You really need to put a brick or piece of wood behind the pedal to prevent it going too far.
You really need to put a brick or piece of wood behind the pedal to prevent it going too far.