Domelight Switch

[Rowdy]

I am missing the page in my JS that show the domelight switches and bezels. I am curious as to which switch and bezel is correct for my 130-A Deluxe Delivery. I have a good domelight, but the switch assembly is one of the few parts I am missing. Any help would be appriciated. Thanks Rod

 

[Charles Reese]

here u go ... no mention as to the 'switch' ... maybe incorporated in light itself?

 

[Rowdy]

Thanks, I have that page, just not the page with the switches which were seperate. I apriciate the attempt. Maybe the switches are not shown in the JS, but I was thinking they were. Rod

 

[Brubaker]

Rod, this may be the one you're after. I'll need to take it off eventually as it isn't correct for a/the '31 standard fordor. Toggle obviously doesn't fit either.

 

[Bruce Rossiter]

I'm not sure if this is a Ford dome light switch and bezel so maybe someone here can identify it.

 

[Bruce Rossiter]

Per the book "Automotive Hardware and Trimming Supplies" published by Ford, it appears to be 1935-1938, depending on the color. Depending on the hole spacing, the switch may be the same as a Model A.

Don Turley
www.donturley.com

Don, Thanks for the information on the switch. Its a chocolate brown (darker than the picture shows) and the hole spacing is 1 1/2 inches. The overall length is 2 3/16" and the width at the widest point is 15/16".

 

[Bruce Rossiter]

I measured a Model 'A' switch bezel and the hole spacing is also 1-1/2".

The "Hardware" book I mentioned in my previous post says:
1935 is Butler finish or Dark taupe
1936 is Brown or Benton gray
1937 is Rustic Brown
1938 is Zephyr beige
The book does not give information on the actual switch. The one in your photo looks just like the Model 'A' switch. I feel pretty sure that it would work on a Model 'A', using the correct bezel.

Don Turley
www.donturley.com

Don,
Thank you very much for the additional information as it is always appreciated.