Does anybody sell just one?

[Walt Ebie]

I'm looking for just one bolt that seems to be sold only in sets of four. Depending on which place you look, it's a Radiator Shield Mounting Bolt, a Hex Radiator Splash Shield Mounting Stud, or a Radiator Apron Mounting Stud. Problem is I sheared off a bolt in one of the Mounting Studs and followed that up with using one of these screw removers and then sheared it off IN the mounting bolt. So unless I can find a way to remove the bolt and remover from the stud I'll have to bite the bullet and buy a set of four unless someone knows where they're sold one at a time.

 

[C26Pinelake]

How much are we talking here, less than 5 dollars a set ? Wayne

 

[700rpm]

Yeah, the price of experience.

 

[J Franklin]

But you will have three spares for your friends.

 

[Walt Ebie]

Yeah, I could give them out as door prizes at the next club meeting! Just what everybody needs. Especially me.

 

[ron103140]

Walt, I may have one original in my stuff. I will look this morning and get back to you if you still need it. My email is ron36109@aol.com. Ron

 

[Quigley1930]

There are two lengths. I have two but don't know which I have at the moment. Let me know what you need the long or short one. I'll look tomorrow and if I have what you want you can have it for the postage.

Sewall

 

[Art Newland]

Walt... you're a Model A owner... you're supposed to have 3 spares of everything anyway!

 

[1931 flamingo]

Going to cost just as much to ship one as four.....................

Paul in CT

 

[C26Pinelake]

what is the cost for four ? Wayne

 

[stouchton]

Carbide endmill or carbide drill bit can remove a hardened screw extractor.

If it is recessed, a drill bushing with a carbide endmill can work miracles. I simply used the endmill in my cordless drill - took less than a minute.

Remember to use cutting fluid to prolong life of tool...

 

[Tom Wesenberg]

Carbide endmill or carbide drill bit can remove a hardened screw extractor.

If it is recessed, a drill bushing with a carbide endmill can work miracles. I simply used the endmill in my cordless drill - took less than a minute.

Remember to use cutting fluid to prolong life of tool...

I used my Dremel with a small diamond bit to remove same. It's slow, but works.

 

[Walt Ebie]

Quigley.....I need the short one. Hope you have one!

 

[Walt Ebie]

Ron.....I forgot to tell you - I need the short one - goes in the front location.

 

[C26Pinelake]

please don't tell me these are the bolts that sell for $11 dollars a set! Wayne

 

[Quigley1930]

Walt I have one. It's the round one. Yours for the postage. Send me an email if still interested.

Sewall Tyler

 

[Walt Ebie]

Thanks for the offer, Sewall, but I need the short, hexagonal bolt (abt 3 1/4 inches).

 

[Quigley1930]

Walt what I have is the sane as the hexagonal style. It will work just fine but if you are going for judjing then I guess they should match.
Sewall

 

[C26Pinelake]

After all this time and discussion, don't you wish you would have just went ahead and bought the set of four ! Wayne

 

[BILL WILLIAMSON]

At garage sales, always ask, "Got a BOX/CAN of old BOLTS/NUTS/SCREWS"?
Bill Hoarder