Cowl Panel (interior) Clip
- Thread starter Charles Reese
- Start date
Aerocraft
Well-known member
It is attached to the front bolt on either side with the "slot" pointing down. The cowl panel will slide into the clip when installed. It make take a bit of "adjustment" to position the clip correctly since the reproduction cowl panel may not be exactly the correct size. Gar Williams
d.j. moordigian
Well-known member
Charles..
My clips don't look like that, draw an S on apiece(starting at the top of the S) paper and when you get to the bottom pull straight down. That's the side view of my clips. The card board fits in the top part of the S,I think. I think Tom Wesenberg or Steve S??? posted a pic. Hope this helps, Dudley
PS...2 clips one left an one right, at the most forward bolts that hold the tank to the cowl.
My clips don't look like that, draw an S on apiece(starting at the top of the S) paper and when you get to the bottom pull straight down. That's the side view of my clips. The card board fits in the top part of the S,I think. I think Tom Wesenberg or Steve S??? posted a pic. Hope this helps, Dudley
PS...2 clips one left an one right, at the most forward bolts that hold the tank to the cowl.
d.j. moordigian
Well-known member
Charles... That is it !!
Charles Reese
Well-known member
this is essentially the same as mine except mine do not have the circle tab which i think held a rubber grommet and an electrical wire for the wiper. mine has a hand wiper. thanks for taking the trouble to include pix .. really helps!!