Chevy distributor conversion questions.

This seems to work better, gives more adjustment.
 

Attachments

  • bracket.jpg
    bracket.jpg
    17.3 KB · Views: 35
Nice job on the hold down.

I have heard some members make their own springs. I don't know how that is done.

Please post up whatever spring option you find that works.
 
Will do Scotty, weather was nice today so I ran it some more, the hold-down clamp works OK but think I will eventually make a setup like yours. Next I need to figure out where 24 degrees is at on the pulley. I set the stop on the advance mechanism at 10 degrees, that's 20 on the crank, got it a bit before the dot on the pulley so I should be close.
 
You must log in or register to reply here.
Back
Top