Carburetor base gasket

Reelnative

Reelnative

Member
The base gasket on my Tillotson carburetor is leaking, can I skip the gasket and use permatex liquid gasket or just cut a new one out from sheet gasket?
 
Not an expert on Tillotson but they tend to warp so make sure the surfaces are flat. I would not recommend using a liquid gasket. Gaskets are available or cut your own. Don't over tighten the screws.
 
I checked it and it is straight, I don't think I over torqued them, maybe not tight enough. I will make one tonight from 1/32 material and re-torque them after running a while.

Thanks
 
Good thick material helps keep heat away from the carburetor base. 1/32" is pretty thin for a base gasket.
 
You must log in or register to reply here.
Back
Top