Brake shaft lube question

M

MurphyJ

Senior Member
Stock 31 closed cab pickup with later version of the emergency brake cross shaft that does not have the lube fittings on each end like the earlier version had.
My question is: How does one lubricate shaft ends where they
mounted on the frame? Thanks for any tips or suggestions.
 
They were designed to NOT be lubricated!!!

The originals were a steel or zinc shell with a material that had a brass screen with woven 'cloth' that appears to be impregnated with graphite.

No lubrication is needed or wanted at this point. Oils and greases attract dirt and can cause binding. You do not want your brakes stuff to bind.

They would fit snug, but a little wear will not affect function on either brake shaft. Yes, the same bushings are used on the service brake shaft.
 
I've seen the time ,on cars that had sit up for long periods of time where the shaft would be stuck. In such cases, I disconnect the emergency brake rods and covers , spray liberal amounts of penetrating oil on the bushings and tap the levers on the shaft back and forth until the shaft frees up. In regular use, no lube or grease will be needed. If the material is worn out in the bushings, the shaft won't be stuck but the bushings will need replacement.
 
You must log in or register to reply here.
Back
Top