Banjo pinion removal tool

deuce lover

deuce lover

Well-known member
Found this in a thread on the HAMB.Anyone here tried it this way?
 

Attachments

  • pinion removal tool.jpg
    pinion removal tool.jpg
    15.1 KB · Views: 124
I tried it that way with a screw jack as shown in the vern Tardel book and it warped the housing out of round. I ended up buying a cheap hydraulic press and borrowed an exhaust fitting/press tool from local shop to press it out. I then was able to use the press and re shape the housing back round.

445452
 

Attachments

  • 20200529_145431_resized_2.jpg
    20200529_145431_resized_2.jpg
    34.4 KB · Views: 200
Will D said:
I tried it that way with a screw jack as shown in the vern Tardel book and it warped the housing out of round. I ended up buying a cheap hydraulic press and borrowed an exhaust fitting/press tool from local shop to press it out. I then was able to use the press and re shape the housing back round.



445452
Click to expand...
I agree.. pressing it from the top is a better option.

Sent from my SM-G975U using Tapatalk
 
Back in '67 I changed out a 4.11 to a 3.54 in a '34 banjo.I used an aluminum drift and hammered it out.Worked but don't want to do it again like that.
 
Build a "bridge" thru the housing like in the picture and press it off the pinion without loading the housing. Shouldn't need heat with an adequate press.

A bottle jack on the inside may work; but you don't want your job to be the time it didn't.
 
rich b said:
Build a "bridge" thru the housing like in the picture and press it off the pinion without loading the housing. Shouldn't need heat with an adequate press.
Click to expand...

Yes... For my 34, this is the way I did it. If I can find the old picture, will edit/add to this post.
 
Will D said:
I tried it that way with a screw jack as shown in the vern Tardel book and it warped the housing out of round. I ended up buying a cheap hydraulic press and borrowed an exhaust fitting/press tool from local shop to press it out. I then was able to use the press and re shape the housing back round.

445452
Click to expand...

This is exactly the way I do it - there is no load on the housing itself - which is the way you want to do it. Also, you're going to need a press anyway to get it back together (easily) - even with the pinion frozen - so might as well buy one if you don't have one. :D
 
You must log in or register to reply here.
Back
Top