Bob G/Spanaway
Senior Member
Can anybody tell me how to use a growler?
Armature Growler
- Thread starter Bob G/Spanaway
- Start date
Bob G/Spanaway
Senior Member
You don't want to feed 'em too good or one of those trespassers will cook and eat them!
Kurt in NJ
Well-known member
The Lelay manual is a wealth of information
http://www.scribd.com/doc/3093121/LeJay-Manual
plan 22 on how to make a growler
plan 28 has article on how to test
http://www.scribd.com/doc/3093121/LeJay-Manual
plan 22 on how to make a growler
plan 28 has article on how to test
You lay The armature in the bed of the growler and turn the growler on; Holding a hacksaw blade horizontal across the laminates you turn the armature with one hand and watch for vibration or the hacksaw blade being sucked to the armature laminates this would indicate a short. Here is a short youtube video http://www.youtube.com/watch?v=yXQ0heuV6VE. If you really know what your doing with a growler you can reverse engineer the winding connections.
Attachments
oldford2
Well-known member
Bob,
55 years ago when I was in high school I worked in a gas station/garage. Back then most garages did all repairs from oil/grease jobs to tuneups, brakes, mufflers. etc.. We didn't rebuild engines just carbs, distributors, pumps, etc.. I learned a little about turning a wrench. The boss did the starter/generator work. the armature machine we had would turn the comutator, then clean the grooves and then he would put it in the V growler. I believe he would turn it on and slowly rotate it which made the growling noise. As he turned it he would hold a hack saw blade on the top which was magnetized and hold the blade tight. If not, that part of the winding was dead.
Now that is my only recollection of a growler. I am sure the guys here will give a better explanation on how to use it. I may even be wrong on this. But it brought back some memories of that garage.
John
55 years ago when I was in high school I worked in a gas station/garage. Back then most garages did all repairs from oil/grease jobs to tuneups, brakes, mufflers. etc.. We didn't rebuild engines just carbs, distributors, pumps, etc.. I learned a little about turning a wrench. The boss did the starter/generator work. the armature machine we had would turn the comutator, then clean the grooves and then he would put it in the V growler. I believe he would turn it on and slowly rotate it which made the growling noise. As he turned it he would hold a hack saw blade on the top which was magnetized and hold the blade tight. If not, that part of the winding was dead.
Now that is my only recollection of a growler. I am sure the guys here will give a better explanation on how to use it. I may even be wrong on this. But it brought back some memories of that garage.
John
Bob G/Spanaway
Senior Member
Thanks guys.
I think I'm finally getting it figured out.
Me and electricity have never gotten along very well.
I use it to start fires.
I think I'm finally getting it figured out.
Me and electricity have never gotten along very well.
I use it to start fires.