8BA/8RT flathad

J

jhexide

Junior Member
Had it all rebuilt ,how to put in distributer , and set timing,the only timing mark i see on the crank pully is a little diamond shape,
what is the firing order and is this number 1 the rotor it pointing to

thanks
 

Attachments

  • timimg02.jpg
    timimg02.jpg
    41.2 KB · Views: 68
  • timing01.jpg
    timing01.jpg
    64.3 KB · Views: 67
  • Distributer.jpg
    Distributer.jpg
    50.4 KB · Views: 105
This should help you. I believe dot on crank pulley would be TDC mark for cyl. # 1. Once you rotate crank in its normal direction with pointer lined up with crank dot should be TDC for # 1 cal; then rotor would be closer to 6 o'clock position.
 

Attachments

This is the wiring diagram,as viewed from right (passenger side of car)
normal in USA. Lets not get the old port and starboard mess going again"LOL" Also note #1 is at the 6 o'clock position on the cap.

R
 

Attachments

  • flathead wiring.jpg
    flathead wiring.jpg
    99.2 KB · Views: 56
Ronnie said:
This is the wiring diagram,as viewed from right (passenger side of car)
normal in USA. Lets not get the old port and starboard mess going again"LOL" Also note #1 is at the 6 o'clock position on the cap.

R
Click to expand...

I always set my distributors with #1 at about the 9 o'clock position. But you can really put it wherever you want to with #1 at TDC or pointing at the dot.
 
flatjack9 said:
I always set my distributors with #1 at about the 9 o'clock position. But you can really put it wherever you want to with #1 at TDC or pointing at the dot.
Click to expand...

Yes for sure you can really put anywhere and then follow firing order,and fine tune from there.Guaranteed to start with that approach.

R
 
great,thanks everyone for their advice,
also do i need a resister in the coil circuit,im using a pertronix conversion in my distributor
 
Then it becomes a 12 versus 6 volt issue, positive versus negative ground. Good advice to contact Pertronix. They are very helpful, and the life of the device depends on it.
 
I like to put number 1 at the 2 o'clock position. Makes it easier with the plug wires.
And consider the Pertronics coil with your ignition.
 
you didn't mention if the car has been converted to 12volt. Pertronix makes both a 12volt negative ground and a 6 volt positive ground unit so be sure to tell them which you have. If you can find a part number on the unit that would also help them recommend a coil.
 
Its not in a car yet,hunting a Model A
Its on a stand need to fire it and breakin
I have a purple coil that i used in my inline chevy 6
With a pertronix dist but put an hei in it
 
If you're talking about 20 minutes to break in the cam, fine. Otherwise, I don't think trying to do a complete "break in" of your engine on a test stand is a good idea. There is no load on the engine, and there may be problems with the rings seating (this may not be a problem with the new moly rings). On mine, I use the stand for the initial start-up, leak checking, and cam break in and then it goes on a storage stand until it's ready to go into the car. It's tempting to sit there and watch the fruits of your labors every day or two, but probably not a good idea. "Ol' Ron" may have more to add.
 
You must log in or register to reply here.
Back
Top