6 volt turn signals

[Steve Rinaldo]

I am installing turn signals on my car. I am using the cowl lights for the front. Does anyone a source for a 6 volt assembly for the rear?

 

[Anteek29]

On my '41 p-u I am using the original 6 volt brake lights but with double filament incandescent bulbs for 64 CP total each bulb. My turn signal switch has 8 wires.

 

[Curtis in MA]

I use an LED bar in the rear window.
That is where people look for your brake lights

 

[katy]

I mounted a RH tail light the same as the LH one and used the brake light portion of both.

 

[katy]

That is where people look for your brake lights

Never heard that one before, I guess I'm just old school.

 

[bavArian]

Does anyone a source for a 6 volt assembly for the rear?

I'm running these turn signals in the bumpers:


https://www.snydersantiqueauto.com/product.htm?pid=984157&cat=41729


They look decent and work well.

 

[arnhemmer]

I use 6 volt double filament incandescent cowl lights and led s for the tail lights. I know the led s are not original looking but in today's traffic i want them to know when I'm slowing down, turning or stopping. They are a lot more visible and people seem to react a lot faster after I installed them.

 

[Patrick L.]

The cowls or parks are fine for the front.

What is wrong with using what you have for the rear ? [ assuming you're using two lights in the rear].
If you want to convert to LED in the rear then all the vendors seem to have them.

 

[bob from red oak]

Like Katy said on my 41 the signal kit runs the rear wires off the brake light switch and you use the brake lights for the rear turn lights