46 convertible cowl adjustment brackets

[tracy46SDCNV]

Good day everyone

I had my rocker panels replaced and the body shop failed/neglected/refused to put the cowl adjustment brackets back on. Does anyone have a drawing-illustration on where they go? A buddy gave me some pictures of his original car but is hard to tell from those. Body shop gave me all those brackets back in a box. The top of the w/s post leans to rear too far now and hits the vent frame assembly. Weatherstrips are installed. need about 1/4" + adjustment.
I did not disassemble that portion of the car so am totally lost.
Thank you everyone in advance,

 

[J.D.G.]

Here is a zoomed in picture from a ‘41 Mercury Convertible off Bringatrailer.com. This is one of the only pictures I could find showing them. It is kind of hard to see since it is body color but appears to attach to the front running board bracket. I have the adjuster brackets from mine but no holes in the rocker to attach them. Still trying to figure out what’s going on.

 

[petehoovie]

Here is a zoomed in picture from a ‘41 Mercury Convertible off Bringatrailer.com. This is one of the only pictures I could find showing them. It is kind of hard to see since it is body color but appears to attach to the front running board bracket. I have the adjuster brackets from mine but no holes in the rocker to attach them. Still trying to figure out what’s going on.

 

[flathead48]

Right where the running board support is under the body to frame bracket (just to left of lift arm)is where a 3/8 bolt screws thru the running board support through a welded nut from the bottom & pushes that body to frame mound up or unscrew the bolt & bracket comes down. That is the cowl adjustment