'41 PU Rear Window

Is someone willing to show a few pictures of the metal that would need to be cut or trimmed? I'm only familiar with the 1935-39 rear window opening and it would be interesting to see the difference.
 
Sorry, I can't, I have already installed my non sliding window & moved on....as i recall when the opening was ready there was a vertical brace on both sides of the window that would have needed to be cut out so the sliders could then move out of the opening. I don't remember if it was just those 2 pieces or not, as i said if i would have cut those out, then continued with Bob Drake installation instructions & found something else as a problem I might have faced reinstalling those 2 pieces, was not willing to got here, I am trying to install as many Period Correct options of 1947, was disappointed to not get this one done.....
 
No problem. I was just curious. On my sliding rear window the glass pains both slide inward, not outward. All that was needed was a clear opening, the same size and shape as the one-piece unit.
 
I bought one for my 41, my question is what does the outside of the window look like, the kit from Drake comes with a nice trim strip for the inside but i don't see anything for the outside. Did they have trouble with air or rain leaking in? I assumed it would use the rubber molding but that isn't the case. Does the window lay against the cab window seam? what keeps rain from getting in? I would love to see a closeup picture of a Drake window installed if anyone has one? Thanks Ron
 
The rear window glass should have setting tape applied to the edge. The tape should be wide enough to go up the glass about 1/4" on each side. The tape provides the rain seal on the cab sheet metal. Ford used this technique on windshields before the advent of rubber gaskets. Attached is an image of a windshield cross section just to show how the tape wraps around the glass. The same principle applies to the rear window glass.
 

Attachments

  • Windshield cross section.jpg
    Windshield cross section.jpg
    24.3 KB · Views: 39
The cross section doesn't look like what I got from Drake to work with. But in any case the outside of the window is going to look unfinished. I don't see any way the Bob Drake kit doesn't allow for leaking inside the cab. Pretty disappointing. Am I missing something?
 
Model51 said:
The rear window glass should have setting tape applied to the edge. The tape should be wide enough to go up the glass about 1/4" on each side. The tape provides the rain seal on the cab sheet metal. Ford used this technique on windshields before the advent of rubber gaskets. Attached is an image of a windshield cross section just to show how the tape wraps around the glass. The same principle applies to the rear window glass.
Click to expand...
566371
 
You must log in or register to reply here.
Back
Top