39 ford pickup front wishbone

Just an aside. Mounting the wishbone ball that low will mess up the caster setting on the vehicle. You may have to "pie-cut" the wishbones to bring it back into spec. I have used a cheap magnetic "angle gauge" to determine an approximate setting.
 
You need to check the caster angle. Your set up looks like you will have way too much caster. Should be 4-6 degrees. Put an angle finder on your axle next to the kingpin.
 
I have already cut out the pie and welded up. I had 7 degrees at original position before moving the wishbone down and I put it back to 6 degrees.
 
You must log in or register to reply here.
Back
Top