39 deluxe cat whiskers

[jstrez5]

any one out there know where you can buy cat whiskers for a 39 ford deluxe upper hood ornament that are in stock. thank you JIM

 

[convert 40]

I think Bob Drake Has Them

 

[petehoovie]

any one out there know where you can buy cat whiskers for a 39 ford deluxe upper hood ornament that are in stock. thank you JIM

 

[jstrez5]

They did but unfortunately out of stock now. Thanks for your reply

 

[Lawson Cox]

They did but unfortunately out of stock now. Thanks for your reply

Bob Drake is OUT OF STOCK ????? You gotta be shittin'. me. ROFLMAO

 

[ford38v8]

Bob Drake is OUT OF STOCK ????? You gotta be shittin'. me. ROFLMAO

Bob, AKA B.O.B. (Back Order Bob)

 

[TJ]

Call around to other vendors as someone may have a pair on the shelf.

 

[jstrez5]

called around located a pair from MIDWEST EARLY FORD from ohio thanks guys for all your help jim s.

 

[Steve/IL]

Joe's Antique Auto
508-278-3980
Eastern Time
Highly recommended by just about everyone on Ford Barn

 

[Eddiebegood]

Ok,what are cat whiskers.

 

[ford38v8]

Ok,what are cat whiskers.

I used to own a '39 DeLuxe myself, and must admit, I didn't know either till I saw the picture on Post #3 above. Wish I had that '39 again!

 

[TJ]

Ok,what are cat whiskers.

Look at the original post which has a clear picture of "cat whiskers".

 

[Karl Wescott]

I am now working on these. I was able to successfully model in 3D cad. Much to do: finish the inside mounting tab detail, make molds, etc. No time frame, no price estimate yet. When ready I will announce in the new products thread.


Photos are of an original and the first plastic model. Note the discoloration in the middle of the model is where I had to weld two halves together as my printer is not big enough for single print.

 

[petehoovie]

I am now working on these. I was able to successfully model in 3D cad. Much to do: finish the inside mounting tab detail, make molds, etc. No time frame, no price estimate yet. When ready I will announce in the new products thread.


Photos are of an original and the first plastic model. Note the discoloration in the middle of the model is where I had to weld two halves together as my printer is not big enough for single print.