38 Ford club convertible

[johnny]

I need a tracing [pattern] of the rear bumper arm cut out opening ,on the rear lower panel under the deck lid. I have a new panel but have no idea of the location and size of the cut out. If someone could lay a piece of paper on the panel and do a dirty finger rubbing or a pencil rub that would be great I would pay for your troubles. Johnny.

 

[deuce b.b.]

I have 38 sedan in shop and I am only 45 minutes north of London , you are welcome to come over with your panel or pencil an paper , and do your measurements , dent

 

[johnny]

bump

 

[my4dv8]

if you already have the rear panel welded on can you use a straight edge between the chassis holes to get the centre of the bumper iron slot. then use the bumper iron rubber grommet to get the total hole size required. just bear in mind that your chassis may have damage history as may another that you use as a pattern, could cause problems.