35/36 Pickup Seat Base

Model51 said:
None of the 1935-36 truck seat base plywood I've seen have the three hole re-enforcement plate on the seat base or the recessed area. Same for all of the Ford engineering parts drawings for this truck part.
I'm not sure why there are pickup seat bases with the grove cut but no plate installed.
Click to expand...

The truck seat base blueprint you sent me illustrates the recessed pockets surrounding the adjustments holes. Did they not actually build them this way?
 
I honestly don't know if the 51-815360-A2 drawing represents a part Ford put into production or not. Unfortunately the dates in the upper top right hand corner are not clear enough to read and I also don't have any of the Engineering Parts Release cards to know what this part was used for or when. The drawing shows a hardwood multi-piece design which is different than the "normal" one which is made from plywood. It's possible this design is intended for the rare instance of a Panel Truck with an 18 gallon tank. There's no cab wall behind it so it needed a different design seat. This is all just speculation on my part but this drawing just doesn't fit into my knowledge base very well.
 
One final comment. Notice the part number ends in -A2. To me this indicates that there at least two versions of -A. I've only seen this nomenclature when there are two versions of the same part from two different vendors. It's likely that the -A1 version is plywood and the -A2 is assembled from hardwood pieces. Again this is more of my speculation since I don't have a copy of the -A1 drawing or any of the release cards which would likely definitively provide the answers.

At this point I'm not sure that anyone would which version was used especially since this part ends up not visible unless you take the seat out of the truck and flip it over.
 
Hello Folks,
Does anybody have a seat or a seat base for a 1940-1941 Pickup that they can measure for me? I am trying to help someone with a seat base for his 40 Pickup and trying to nail down an accurate measurement for the seat back hinge plate spacing. Any help would be very much appreciated by both of us.

Thanks!
 
You must log in or register to reply here.
Back
Top