32 steering box location

Q

quinton

Junior Member
Would like to know the best way to locate the stock 32 box shaft location,also im going to use a 56 f100 box,is the stock location the best place for it or maybe a little off that mark,thanks
 
30 on pinched 32 with 392
need stock 32 steering sector hole location,i think its 35 11/16 back from the 2nd spreader bar hole c/l to c/l,is this right and how far from the top of the frame rail..thanks
 
I measure 36 3/8" to c/l of sector hole and 2" down from top flange. Keep in mind my dimension for the length is with a tape on the diagonal, not using vertical locations along a leveled frame. I assume you pulled the 35 11/16 dim. from a frame b/p.

Scribe a line down from the top @ 2" and then measure the 36 3/8", center punch where that falls on the scribed line and you're there.
 
Having the original location dimensions is fine, but I wouldn't drill any holes until I did a complete mockup to make sure I had clearance............especially with a hemi!
 
You must log in or register to reply here.
Back
Top